100CS Quattro Wagon V6-2.8L (AAH) (1992)
/Page-1847001.png)
Flex Plate: Adjustments
NOTE: Part numbers are listed for reference only. Always check with your Parts department for the latest information.
1. Install drive plate with 3.0 mm shim -1-(Part no.054105301) or 4.0 mm shim -1- (Part no. O54 105 202), and spacer-2- (Part no. 035 105 303A),
or equivalents.
NOTE:
^
Short blocks are supplied without a bushing in the crankshaft.
^
For vehicles with automatic transmission, tap the bushing into place before installing the drive plate.
^
Before installing the engine, make sure that the engine to transaxle dowel sleeves are installed in the cylinder block flange.
2. Check clearance -a- between drive plate and cylinder block in three places and calculate average value.
Dimension -a-: 18.1-19.7 mm (0.713-0.776 inch).
3. If necessary, install other shims to achieve correct clearance dimension.
TIGHTENING SPECIFICATIONS
Mounting Bolt: 60 Nm (44 ft. lbs.) plus 1/4-turn (90°).
