100S Quattro Wagon (Canada) V6-2.8L (AAH) (1992)
^
removing/installing, see section 90-70
^
troubleshooting, see section 90-190
5 - Analog clock
^
removing/installing, see section 90-70
^
troubleshooting, see section 90-210
6 - Engine oil temperature gauge
^
checking, see section 90-130
^
removing/installing, see section 90-70
^
troubleshooting, see section 90-210
7 - Engine oil pressure gauge
^
checking, see section 90-130
^
removing/installing, see section 90-70
^
troubleshooting, see section 90-210
8 - Instrument support (side panel)
9 - Warning light housing (side panel)
10 - Printed circuit (side panel)
^
removing/installing, see section 90-70
11 - Cover (side panel)
12 - Radio/parking light warning buzzer (J152)
^
installation position, see section 90-30
13 - Warning buzzer bracket
14 - Gear selector display
15 - Fuel gauge
^
checking, see section 90-90
^
removing/installing, see section 90-70
^
troubleshooting, see section 90-200
16 - Multi-pin connector, red (instrument panel wiring harness)
^
terminal identification, see section 90-50
^
removing/installing/repairing connector, see section 90-60
17 - Six-pin connector for printed circuit (side panel)
^
terminal identification, see section 90-50
18 - Voltage stabilizer with heat sink checking, see section 90-90
19 - Outside temperature display with 5-pin connector
^
removing/installing, see section 90-70
20 - Cover
21 - Opening for adjusting board computer range calibration
22 - Printed circuit for Auto-check system and Board computer
^
with fuel consumption correction switch and country code switch
23 - Coding connector (plug) for Board computer
24 - Board computer potentiometer (range calibration)
25 - Instrument panel light dimmer switch
^
removing/installing, see section 90-70
26 - Multi-pin connector, green (instrument panel wiring harness)
^
terminal identification, see section 90-50