100S Quattro Wagon (Canada) V6-2.8L (AAH) (1992)
/v6-2.8l_(aah)/Page-2575002.png)
Carefully pry cover strip 1A from roof molding 2A. In area AA above the B-pillar make three (3) 1 mm deep indentations 10 mm apart with a round
nose punch or a center punch.
Reinstall the B-pillar trim by screw 4 in the front first then the two lower screws 2. Install screw 4 in the rear last. Install the cover cap insuring the
locking tab locks in place. If the lock tab does not hold securely, use clear silicone on the heads of screws 2 and allow to dry sufficiently.
If new roof moldings 4A5 853 703G/704G 01C and cover strips 4A5 853 709C/710C 01C are installed, they will also require peening.
