4000,S L4-1715cc 1.7L SOHC (WT) (1982)
Hall Effect Sensor: Technical Service Bulletins
Ignition Distributor - Trigger Wheel Removal
Applies To
4 and 5 cyl.
Gas engines
w/electronic ignition
Group 28
Subject
Ignition Distributor Trigger Wheel Removal
Part Identifier
2839
Key Points
Hall sender replacement
A 294
Number
87-01
June 8, 1987
When replacing the Hall sender in ignition distributors with centrifugal/vacuum advance, the trigger wheel must be removed. Use puller 3163* to avoid
damaging the trigger wheel and distributor housing.
Install the puller as follows:
4 cylinder engines
-
remove circlip on top of trigger wheel
-
install hooks 1 and 2 as shown
-
center 1363* tensioning bolt on top of distributor shaft
-
slowly tighten bolt and withdraw trigger wheel
-
remove and replace Hall sender
Note