5000CD Turbo (Canada) L5-2144cc 2.14L SOHC Turbo (KH) (1984)
-
Using tool 2079, turn crankshaft until trigger wheel window (arrow) is fully aligned with Hall sender
-
Check voltage reading
^
Specification: minimum 4.0 V
-
Using tool 2079, turn crankshaft until trigger wheel window (arrow) is clear of Hall sender
-
Check voltage reading
^
Specification: 0-0.5 V
-
switch ignition OFF
If specification NOT OK
-
Replace Hall sending unit
If specification OK
-
Check wiring for open circuit between Hall sending unit and control unit connector
-
Remove control unit cover located in footwell on passenger side of vehicle
-
Unplug control unit connector