5000CD Turbo (Canada) L5-2144cc 2.14L SOHC Turbo (KH) (1984)
FIGURE 2
Work sequence
-
remove center console (see 5000S and 5000 CS Turbo Center Console, Removing/Installing)
-
remove self locking nut (3) from selector lever pivot bolt and discard
^
do not remove bolt nor allow to slip out of shifter
-
slip teflon washer (4) onto pivot bolt
-
slip teflon washer (4) onto step washer (2)
-
fit stepped washer into dished recess of lockout bracket (1)
^
smaller diameter faces towards selector lever bracket
-
slip lockout bracket (1) together with step washer
(2)
onto pivot bolt
-
attach self locking nut (3) and tighten Tighten only until seated. If too tight, shifter will bond. If too loose, bracket could engage improperly.
Note
If a self locking nut is not included in the kit then use the nut provided along with an application of Loctite (R).
^
torque non self locking M6 nut N 011 006 023L:
5.6 N-m (4.1 ft.lbs.)
CAUTION Ensure that there is no obstruction to shifter movement or smoothness, after installing lockout bracket (1).
-
assemble lockout solenoid (5) to solenoid bracket
(7)
using two small bolts
-
install lockout solenoid assembly
-
position lockout solenoid bracket (7) to tang (arrow) on selector lever bracket
-
secure solenoid bracket (7) to selector lever bracket with machine screw (9) which has been first inserted into small step washer (8)
^
smaller face of step washer (8) faces solenoid bracket (7)
^
carefully center and position before tightening