audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Engine Control Module|Flow of Diagnosis|Page 2222 > < Understanding Track Style Wiring Diagrams, Important Stuff !|Page 2219

5000CS Quattro Wagon L5-2226cc 2.22L SOHC Turbo (MC) (1988)

Page 1
background image

Engine Control Module: Flow of Diagnosis

NOTE:  Connect and disconnect central connector for control unit with the ignition switched OFF. Do not damage contacts in terminal. Always check
all connections being used. If the specified values are not attained, disconnect terminals and check if lines are open or if components are defective.

TEST CONDITIONS

-

disconnect high tension wire from ignition coil on ignition distributor and connect to ground

-

disconnect central connector from CIS-E control unit

-

use multimeter US 1119 and switch to DCV 20

NOTE:  Refer to current flow diagram when tracing circuits.

Sequence 1

Engine Control Module|Flow of Diagnosis|Page 2222 > < Understanding Track Style Wiring Diagrams, Important Stuff !|Page 2219