5000CS Turbo L5-2226cc 2.22L SOHC Turbo (MC) (1987)
^
disconnect connector 2 at warning light switch
^
disconnect pressure line 3 at brake servo
^
remove storage compartment, driver's side
^
remove footwell air outlet
^
remove securing clip from clevis pin and withdraw pin from clevis
^
disconnect brake servo from bulkhead
^
remove hydraulic brake servo carefully
Clevis, adjusting
^
transfer clevis from old brake servo to new brake servo
^
adjust clevis:
Note
Before measuring, fully extend push rod outward from brake servo. Be sure clevis is positioned, as shown.
Clevis adjustment dimension a depends on VIN number:
Up through VIN 44 JN 201 030:
^
a - 249.0 +/- 0.5 mm
From VIN 44 JN 210 031:
^
a = 230.0 +/- 0.5 mm