5000CS Turbo L5-2226cc 2.22L SOHC Turbo (MC) (1987)
housing
^
strip 7 mm (1/4 in.) of insulation from one end of new black 1.0 sq.mm (18 gauge) wire
^
strip 7 mm (1/4 in.) of insulation from one end of new brown 1.0 sq.mm (18 gauge) wire
^
properly crimp copper spade connector 3 P/N: N 017 461 4 onto stripped end of each wire (two connectors necessary)
^
install black connector housing 4 P/N: 161 971 976 A over each new spade connector (two housings necessary) until tab on connector locks into
housing
^
tape brown and black wires together approximately every 20 cm (8.0 in.) with electrical tape
Note
Heat shrink tubing (available locally) cut in 2.5 cm (1.0 in.) strips and spaced every 20 cm (8.0 in.) can be used in place of electrical tape to secure the
wires together.
^
connect new black and brown wires to existing horn wiring harness by inserting white connector housing into black for each wire.
Note
The new black and brown wires can be connected to either wire on the existing harness. Wire polarity will not affect horn operation.
^
route new horn wiring harness around front of radiator (right arrow) and across front apron (left arrow)
Note
When positioning new horn wiring across the front apron, follow the same routing as the alternator/headlight wiring harness.