5000S Quattro Sedan L5-2309cc 2.3L SOHC (NF) (1988)
Control Arm Bushing: Technical Service Bulletins
Rear Control Arm Support - Replacing Rubber Bushing
Group: 42
Number: 93-03
Date: May 30, 1993
Subject:
Replacing bonded rubber bushings in rear control arm support
Model(s):
5000 Quattro, 100/200 Quattro (C3)
from VIN 44G 070 703
In addition to the rear control arm support/bushing supplied as a replacement part, the bonded rubber bushings are also available as single replacement
parts.
This bulletin describes the replacement of the bushing for the control arm support.
When replacing a control arm support bushing always replace the entire bushing. Also, replace the bushings on both the right and left sides of the
vehicle.
The following information will be added to the Audi 5000 and 100/200 Repair Manuals - Suspension, Wheels, at the next filming.
Bonded rubber bushing in control arm support
(from VIN 44G 070 703)
1 - Mounting stud
2 - 170 N-m (125 ft.lb.)
^
always replace
^
clean out threads of control arm with M14 x 1.5 tap
^
tighten only with vehicle standing on wheels
3 - Washer
4 - Bonded rubber bushing
^
replacing, in this bulletin
5 -135 N-m (100 ft.lb.)
^
always replace