5000S Sedan L5-2226cc 2.22L SOHC (KZ) (1985)
-
fit appliance centrally on rim of air flow sensor.
-
point (3) must point towards fuel distributor
-
push in slide (2) to stop
-
tighten adjusting screw (1) until magnetic tip contacts mounting screw on sensor plate (sensor plate in rest position)
-
connect voltmeter to VW 1501 between test leads 2 and 3
-
switch ignition ON
Slide/Fuel Consumption Sender
-
pull up slide (2) of adjusting tool to first stop (idle position)
Specified value:
^
0.2-0.5 V
If NO, - unscrew retaining screws on fuel consumption sender (arrows)
-
move sender in slots until correct reading is obtained
-
tighten retaining screws
If specified value was obtained, - perform full throttle test as follows:
Slide/Fuel Consumption Sender
-
pull up slide (2) of adjusting tool to second stop (full throttle position)
Specified value:
^
4.0-4.5 V
If NO, - repeat test in idle position or repeat basic adjustment of adjusting tool
If specified value was obtained, - push slide (2) down as far as it will go
Specified value:
^
0.0 V
If specified value is not obtained, - repeat test in idle and full throttle position