5000S Sedan L5-2226cc 2.22L SOHC (KZ) (1985)
Throttle Full Open Switch: Testing and Inspection
Non Turbo
IDLE SWITCH, CHECKING/ADJUSTING
-
loosen upper left bolt from throttle valve housing
-
attach pointer and tighten bolt
-
attach protractor 3084 to primary throttle valve shaft (remove nut if necessary)
-
disconnect switch wire plug and connect ohmmeter across open connector terminals
-
zero protractor
-
open throttle approx. 20°, then slowly close again
^
ohmmeter must read 0 ohms at 1 to 2.5°
If NO
-
remove throttle valve housing
-
adjusting idle switch at mounting screws (arrows)
NOTE: Ohmmeter must indicate continuity (0 ohms) before throttle reaches idle position
FULL THROTTLE SWITCH, CHECKING/ADJUSTING