5000S Turbo L5-2144cc 2.14L SOHC Turbo (KH) (1984)
Engine Control Module: Scan Tool Testing and Procedures
Fuel pump relay signal
Work sequence
-
Pull fuel pump relay from relay panel, location number 10
-
Connect voltmeter between terminals 46 and 47 of relay panel sockets
-
Briefly actuate starter
^
Specification: approx. 9.5 V
If specification OK
-
Check fuel pump relay and fuel pump.
If specification NOT OK
-
Connect voltmeter between terminal 46 relay panel socket and ground
-
Switch ignition ON
^
Specification: approx. 12 V
If specification NOT OK
-
Check for open circuit in wiring according to current flow diagram
If specification OK
-
Check wiring between control unit and relay panel as follows
-
Remove control unit cover located in footwell on passenger side of vehicle
-
Unplug control unit connector