80 Quattro L5-2309cc 2.3L SOHC (NG) (1988)
1.
80, 80 Quattro - Rear side panel molding
-
Remove malformed molding
-
Activate bonding area on body with primer D 009300 or with primer from adhesive kit D 004300.03
-
Activate bonding area on molding with primer D 009600 or with primer from adhesive kit D 004300.03
-
Apply adhesive D009100.03 (width 4.00 mm) to molding (marked b)
-
Position molding and press firmly to body
-
Allow to dry 4 hrs. at 20~C (68~F)
2.
90, 90 Quattro - Rear side panel molding The same procedure as it is for the 80, 80 Quattro, except:
-
Apply adhesive D 009100.03 around perimeter (marked a)
-
Fasten moldings to wheel housing with clamps P/N 893853805/806
-
Replace fender and door protective moldings per repair manual group 66
Note:
Follow all applications and safety instructions on labels