90 Quattro Sport V6-2.8L (AFC) (1995)
/Page-1984001.png)
Cruise Control Servo Cable: Adjustments
1. Remove engine cover, then the engine compartment cross support.
2. Remove air hose between mass air flow (MAF) sensor and intake manifold.
3. Remove electrical connectors from MAF sensor and idle air control (IAC) valve.
4. Unclip cover from noise damper and remove mounting screws, then press noise damper back and lift up.
5. Remove crankcase breathers and vacuum hose, then the noise damper.
6. Remove servo linkage safety clip, then pry linkage out of ball stud with a suitable screwdriver.
7. Adjust linkage until clearance is 0.019-0.040 inch (.5-1mm).
