90CS Quattro V6-2.8L (AAH) (1994)
Sunroof / Moonroof Motor: Service and Repair
Sunroof Motor Neutral Position
Sunroof motor "Neutral" position, checking and adjusting
Checking
The sunroof motor is in the "Neutral" position is when the hole and the lug are aligned as shown (arrows).
Adjusting
With drive installed:
- Open roof panel 50 mm (2 in.) toward rear, then close again.
Do not tilt upward, otherwise adjustment will be incorrect.
- Disengage cable drive from sunroof motor by turning release lever -B- in direction shown (left arrow).
- Insert "crank" or hex key -A- (4 mm) into drive pinion, and turn to right until pin on switch latches into cam plate recess (arrow).
Lug and hole must align.
Note: "Neutral" position on cable drive can only be adjusted after turning drive pinion to right.
- Engage cable drive to sunroof motor by turning release lever -B- in direction opposite arrow.
- Follow remaining installation instructions.
Checking end position cut-off