90CS Quattro V6-2.8L (AAH) (1994)
-
.
Main Bearing Cap Bolts (1)
-
Always replace.
-
Tighten to: 60 Nm (44 ft. lbs.) plus 1/2-turn (180°).
Main Bearing Cap (2)
-
Identification " 1 " on side facing oil pump.
Connecting Rod Bearing Cap Bolts (3)
-
Always replace.
-
Tighten to: 30 Nm (22 ft. lbs.) plus 1/4-turn (90°).
Connecting Rod Bearing Shells (4)
-
Never interchange used connecting rod bearing shells.
Oil Pump (8)
-
Check drive gear on crankshaft when installing.
Bolt (9)
-
Tighten to: 10 Nm (7 ft. lbs.).
Thrust Washers (10)
-
Installed only at 4th crankshaft main bearing.
Bolt (11)
-
Manual Transaxle:
-
Always Replace.
-
Tighten to: 40 Nm (30 ft. lbs.) plus 1/2-turn (180°).
-
Automatic Transaxle:
-
Always Replace.
-
Tighten to: 44 Nm (30 ft. lbs.) plus 1/4-turn (90°).
Bolt (16)
-
Thread bolts in hand-tight before tightening crankshaft main bearing caps.