90CS Quattro V6-2.8L (AAH) (1994)
-
Push back protective boot on MAF sensor connector (leaving sensor connected).
Note:
The connector terminals are appropriately identified on the back of the connector:
-
Connect multimeter (Fluke 83 or equivalent) between connector terminals 2 and 1, using adapter cables from VW 1594 connector test kit.
-
Switch ignition on.
Specified value: 0.3-1.1 volts
-
Let engine run, switch all electrical consumers off (radiator cooling fan must not run) and vary engine speed continuously between idle and
4000 RPM.
Specified value: voltage must vary between 1.5 to maximum 3.4 volts, corresponding to engine speed.
If specified values are not obtained:
-
Replace mass air flow sensor.