90CS Quattro V6-2.8L (AAH) (1994)
Fuse Block: Service and Repair
Auxiliary Fuse Holders, Removing and Installing
CAUTION!
Before working on the electrical system:
-
Determine the correct coding for the anti-theft radio.
-
Disconnect the battery Ground (GND) strap.
Removing
-
Remove fuse/relay panel cover.
-
Remove (unclip) fuse/relay panel from housing (leave all connectors attached) and set aside.
-
Remove fuse.
-
Using a small screwdriver, release locking tab on auxiliary fuse holder.
-
Pull auxiliary fuse holder upward (arrow) and out of housing.
Installing
-
Slide auxiliary fuse holder into proper location until locking tab (arrow) engages.
-
Install fuse.
-
Re-install fuse/relay panel in housing.
NOTE: When installing the fuse/relay panel into the housing, make sure that the connector wires do not get pinched.
-
Carefully install fuse/relay panel cover to ensure a tight seal against water.