90CS Quattro V6-2.8L (AAH) (1994)
Ignition Lock Cable: Adjustments
CAUTION: The lock cable should always be adjusted with the cable in the installed position.
-
Loosen bolt (No. 1 in illustration)
-
Turn ignition switch to "on" position.
-
Rotate lock cable in installed position.
-
Insert 1.5 mm (0.059 in.) feeler gauge (A in illustration) between lock flap and locking pin.
-
Adjust lock cable in direction of arrow so that locking pin is pressed against feeler gauge.
-
In this position, tighten bolt (No. 1 in illustration).
-
Operate lock several times.
Clearance between locking pin and locking flap must be 1.2-1.7 mm (0.047-0.067 inch).
-
Move selector lever to "N" position.
-
Mount lock cable on selector lever housing.
It is important to make sure that the lock cable is laid in position free of sharp bends or kinks, and attached with a clip (arrow).
Perform Functional Check see Testing and Inspection