90CS Quattro V6-2.8L (AAH) (1994)
Both jaws of tool 3292 must fit between bushing and wheel bearing housing.
Fig. 8 Pulling out bushing from wheel bearing housing
- Center crossbar 3292/2 and lighten securely to support 3292/1 with hex bolts.
- Pull out bushing by threading in spindle of crossbar 3292/2 (arrow).
Fig. 9 Installing bushing in wheel bearing housing
- Place one half of bonded rubber bushing on each side of at right angle of wheel bearing housing.
- Attach 3293/3 on both sides of bushing and turn threaded spindle until bushing halves are pressed in fully.