Audi Workshop Service and Repair Manuals

Fuse Block: Service and Repair
Auxiliary Fuse Holders, Removing and Installing

CAUTION!
Before working on the electrical system:

-

Determine the correct coding for the anti-theft radio.

-

Disconnect the battery Ground (GND) strap.

Removing

-

Remove fuse/relay panel cover.

-

Remove (unclip) fuse/relay panel from housing (leave all connectors attached) and set aside.

-

Remove fuse.

-

Using a small screwdriver, release locking tab on auxiliary fuse holder.

-

Pull auxiliary fuse holder upward (arrow) and out of housing.

Installing

-

Slide auxiliary fuse holder into proper location until locking tab (arrow) engages.

-

Install fuse.

-

Re-install fuse/relay panel in housing.

NOTE:  When installing the fuse/relay panel into the housing, make sure that the connector wires do not get pinched.

-

Carefully install fuse/relay panel cover to ensure a tight seal against water.