90CS Quattro V6-2.8L (AFC) (1995)
Installing
Installation is the reverse of removal; note the following points:
-
Install steering gear and attach to bulkhead by hand.
-
Tighten steering gear to left wheelhousing with steering damper bracket (2 technicians required).
-
Tighten steering gear to bulkhead with angled box wrench.
-
Carefully place bulkhead seal into position.
-
Attach brake line in holding clip on bracket for steering damper, wheelhousing side.
-
Connect return hose on rotary valve housing and on pressure hose on steering gear housing in such a way that hose does not contact anything.
-
Connect harness connector for Servotronic valve.
-
Attach brake booster to bulkhead and secure, then install bulkhead seal onto bulkhead.
-
Install harness connector for engine coolant temperature sensor at rear coolant line.
-
Install threaded pin.
-
Mount cruise control diaphragm with bracket on throttle body.
-
Connect cruise control vacuum line.
-
Clip in connectors.
-
Connect coil spring to pedal clevis.
-
Install pin in clevis and/or install pedal, and secure with new clip.
-
Connect harness connector for brake fluid level sensor on brake fluid reservoir.
-
Connect hose line for clutch master cylinder on brake fluid reservoir.
-
Remove hose clamps 3094 from supply and return hoses.
-
Connect vacuum hose on throttle body.
-
Connect both crankcase breather hoses to cylinder head cover.
-
Install strut tower crossmember.
Tightening torque: 20 Nm (15 ft lb)
-
Turn steering wheel several times from lock-to-lock (engine not running) to bleed air from steering gear.
Note: If noises occur during the test drive, this procedure must be repeated.
-
Bleed brake system and check for leaks.
-
Bleed clutch slave cylinder.
-
Connect battery Ground strap.
-
Check hydraulic oil level and top off if necessary
-
Check return hose on rotary valve housing for leaks.
-
Check pressure hose on steering gear housing for leaks.
-
Adjust toe.