90CS Quattro V6-2.8L (AFC) (1995)
Installation position - Fig. 7
5. Joint boot with cap
Check for cracks and abrasion
Drive off with mandrel
Before assembly onto CV joint, coat face with D3
6. Axle shaft (splined shaft)
Left- and right-side shafts have different lengths
7. Clamp
Always replace
Tightening - Fig. 1
8. Joint boot
Check for cracks and abrasion
Before tightening small clamp, ventilate briefly - Fig. 2
9. Clamp
Always replace
Tightening - Fig. 1
10. Spring washer
Installation position - Fig. 6
11. Spacer
Installation position - Fig. 6
12. Lock ring
Always replace
Installation position - Fig. 6
During assembly, install in groove on shaft (not visible with joint installed)
13. Constant velocity (CV) joint, outer
Diameter: 89 mm
Replace complete unit only
Pressing off - Fig. 8
Installing: drive on joint with soft-faced hammer until lock ring latches into ring groove of axle shaft