audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

General Information|Page 4461 > < General Information|Page 4459
Page 3
background image

Caution

As noted before in Technical Bulletin, Group 57, # 91-07, always remove the black, (center) connector first, then the remaining connectors to avoid
damage to the pump. When reconnecting, connect the center (black) connector last.

System unlocks itself within a few minutes of locking the doors with the key or the infrared.

Cause:

One of the door lock switches is not returning completely to its neutral position, thus after a few minutes the control unit will think it is receiving an
unlock signal from that switch and unlock the entire system.

Service:

Test each switch individually for proper signals. See pin out sheet for 1598, test terminals 43, 44 and 45

Infrared function is inoperative, cannot reactivate.

Remember, some of the 1994 vehicles had the infrared system disconnected internally in the pumps. Older pumps may have other internal failures.
Factory modified pumps without the infrared system can be identified by a gold sticker, stating, (keine I/R function)

Install the latest version pump, 4A0 862 257G.

Note:

When working on any infrared system complaints, ask the customer to supply both master keys so both can be tested, and in the event a new pump is
installed, both keys can be programmed to assure proper operation of the infrared system when The vehicle is returned to the customer.

For further troubleshooting information, refer to Technical Bulletin, Group 57, # 92-04.

General Information|Page 4461 > < General Information|Page 4459