90S Quattro (Canada) V6-2.8L (AAH) (1993)
Front Bumper: Service and Repair
Front bumper assembly, removing and installing
WARNING!
‹› Do not re-use fasteners that are worn or deformed in normal use.
‹› Some fasteners are designed to be used only once, and are unreliable and may fail if used a second time. This includes, but is not
limited to, nuts, bolts, washers, circlips and cotter pins. Replace these fasteners with new parts where indicated, and any other time it
is deemed necessary by inspection.
1 - Bolt (2x)
23 Nm (17 ft lb)
2 - Cover
‹› Removing from bumper ~ Fig. 3
3 - Bumper
‹› To remove, remove bolts -1- and pull bumper with cover toward front
4 - Trim
Removing:
-
Remove bumper-3-
-
Remove bolts -7-, -8- and -12-
-
Push pin out of expanding clip -6- and pull expanding clip out downward
-
Pull trim toward outside at both ends (second technician required) and remove toward front
‹› Install in reverse order of removal
5 - Fog lights
‹› Removing and installing ~ Fig. 2
6 - Expanding clips (2x)
‹› Before removing trim, press pin toward inside and pull clip out and down
7 - Bolt and washer assembly (2x)
‹› 6 Nm (53 in lb)
‹› Remove before removing trim -4-
8 - Bolt and washer assembly
^
6 Nm (53 in lb)
‹› Remove before removing trim -4-
9 - Nut and washer assembly
^
6 Nm (53 in lb)
10 - Bracket
‹› After assembling trim -4-, bracket must be installed from below