90S Quattro (Canada) V6-2.8L (AAH) (1993)
Camshaft Holder 3243 Shown In Installed Position
- Install camshaft holding tool 3243.
- Loosen left and right camshaft sprocket bolts approx. 3 turns.
- DO NOT remove the bolts.
- Remove camshaft holding tool 3243.
- Loosen right and left camshaft sprockets from tapered ends of camshafts using puller (Kukko 20/10 shown).
- Puller arms must engage on rear of sprocket
- With engine installed in vehicle, use puller 3032
- Loosen and remove toothed belt.
Installing
- Install toothed belt over both camshaft sprockets.
- Install camshaft holding tool 3243.
- Install toothed belt over remaining sprockets, then over tensioner roller last.
Note:
The camshaft sprockets must be loose enough on the tapered ends of the camshafts so that the camshafts can still be turned, but not so
loose that the sprockets tilt out of alignment
Adjusting belt tension
The toothed belt tension adjustment is done by turning the tensioning roller with 8 mm hex-key wrench.
- Adjust tensioner so it can just be moved slightly by hand.