90S Quattro (Canada) V6-2.8L (AAH) (1993)
Fuel Gauge: Adjustments
Fuel gauge, checking and adjusting
Checking
-
Open trunk lid and pull back carpet from right-front side of trunk.
-
Pry off plastic cover using screwdriver.
Note: When installing, glue carpet back in using a spray adhesive (available locally).
-
Disconnect fuel level sensor connector.
-
Set digital multimeter (Fluke 83 or equivalent) to voltage measuring range.
-
Connect multimeter between fuel level sensor connector terminals.
-
Switch ignition on.
Specification: 9.75-10.3 volts
-
Switch ignition off.
If specified value is not obtained:
-
Check for open circuit in wiring according to wiring diagram, repair as necessary.
-
Check voltage stabilizer. See: Instrument Cluster/Instrument Panel Voltage Regulator/Testing and Inspection