90S Quattro (Canada) V6-2.8L (AAH) (1993)
Axle Shaft: Service and Repair
Rear Axle Shaft Assembly/Disassembly
Drive axle with CV joint, disassembling and assembling
Grease (G6) for CV joints
When replacing boot -5- or -8-, grease joint again if necessary.
1. Circlip
Always replace
Remove and install with special tool VW161A (- Fig. 3) or commercially available circlip pliers, depending on version
2. Gasket
Replacing: remove protective backing and adhere to joint
3. Constant velocity (CV) joint, inner
Diameter: 100 mm
Replace complete unit only
Pressing off - Fig. 3
Pressing on - Fig. 4
4. Spring washer