A1
| Exploded view - wing |
| 1 - | Bolt |
| q | 10 Nm |
| q | 7x |
| 2 - | Nut |
| q | 8 Nm |
| 3 - | Wing |
| q | Removing: |
| – | Remove bumper (front) → Chapter. |
| – | Remove wheel housing liner → Chapter. |
| – | Remove end plate → Anchor. |
| – | Unscrew bolts -1- and nuts -2- and detach wing. |
| q | Installing: in reverse order of removal |
| 4 - | Deformation element |
| q | Riveted to wing |
| 5 - | Pop rivet |
| Wing panel brace |
| 1 - | Brace |
| – | Bumper removed; push wheel housing liner to side in area of brace. |
| – | To remove, unscrew bolts -2-. |
| 2 - | Retainer (rear) |
| 3 - | Bolt |
| q | 10 Nm |
| Seal for wing panel |
| 1 - | Wing panel |
| 2 - | Seal (bottom) |
| q | Self-adhesive |
| q | Peel off protective film and slide in seal on wing mounting flange between wheel housing liner and inside of wing. |
| 3 - | Seal (top) |
| q | Slide seal onto wing mounting flange and clip in. |
| 4 - | Wheel housing liner |
| Removing and installing end plate |
| 1 - | Clip |
| q | 2x |
| 2 - | End plate |
| – | Remove front wheel. |
| – | Loosen rear section of wheel housing liner and press to the side → Chapter. |
