A1
Removing and installing bumper cover (rear) |
1 - | Bolt |
q | 2 Nm |
2 - | Cover |
3 - | Bolt |
q | Tightening torque → Item |
4 - | Bolt |
q | Tightening torque → Item |
5 - | Nut |
q | 5 Nm |
6 - | Bumper cover |
– | If fitted, unplug electrical connector at parking aid control unit -J446-. |
– | Prise out cover -2-. |
– | Remove bolts -1-, -3- and -4-. |
– | Remove nuts -5- from inside, bend open side sections at side over guide and detach cover from vehicle towards rear. |
7 - | Expanding nut |
|
1 - | Bumper cover |
– | When removing, cover must first be pulled out to the side over guide. |
– | When installing, make sure that retaining hooks engage completely in guide -arrows-. |
2 - | Bolt |
q | Tightening torque → Item |
3 - | Guide |
4 - | Wheel housing liner |