Note Before attaching the protective film, the component must have a temperature of between 20° C and 60° C. |
–
| Clean bonding surface with cleaning solution -D 009 401 04-. |
–
| Moisten bonding surface with soap solution. |
–
| Detach backing from film and also moisten its bonding surface with soap solution. |
–
| Align film according to rear edge of wheel housing and edge of side member and press on. |
–
| Starting from centre, press out water film between protective film and body. |
–
| Carefully pierce open any remaining air blisters with a needle and press film on again. |
|
|
|