| –
| Unplug the connectors of the wiring harnesses -3- to the seat backrest and lay bare the disconnected wiring harnesses → Chapter. |
Note | There is a continuous wiring harness between the connector point and the side airbag. |
| –
| Fold the seat backrest forwards. |
| –
| Equipment version with easy entry facility: Disengage the support bracket -1- of the Bowden cable for the easy entry facility from the holder at the seat pan frame -arrow-. |
| –
| Equipment version with easy entry facility: Disengage the Bowden cable -4- for the easy entry facility at the backrest fitting. |
| –
| Screw out the bolt -2- at the backrest fitting on the left and right. |
| –
| Detach the backrest from the seat pan. To do so, carefully pull the wiring harness for the side airbag and - depending on equipment version - all other wiring harnesses to the backrest out of the seat pan. |
WARNING | t
| Heed the safety regulations for pyrotechnic components → Chapter. |
| t
| Before handling pyrotechnic components (for example to plug in the connector), the person concerned must „discharge static“, for instance by briefly grasping hold of the door striker plate. |
| t
| Heed the measures to be taken when fitting the front seat → Chapter. |
|
| Install in reverse order. |
| Notes on installation: For example tightening torques, component replacement → Chapter. |
|
|
|
