| Removing and installing vacuum pump for brakes -V192- |
| No provision is made for repairs to vacuum pump for brakes -V192-. If a fault occurs, the vacuum pump for brakes -V192- must be renewed. |
Note | The vacuum pump -V192- is fitted at the front of the engine compartment (right-side). |
| –
| Use suitable pliers to release hose clip on vacuum hose. |
| –
| Detach vacuum hose from vacuum pump for brakes -V192-. |
Caution | Take care not to damage the vacuum hose. The vacuum hose must be renewed if it is damaged. |
|
| –
| Unplug electrical connector. |
Note | Unbolt the bracket to facilitate removal of the vacuum pump from the bracket. |
| –
| Unscrew nuts for bracket. |
| –
| Take bracket with vacuum pump out of vehicle. |
| –
| Unfasten both clips on vacuum pump and detach. |
| –
| Pull vacuum pump for brakes -V192- upwards out of bracket. |
| –
| Insert vacuum pump in bracket. |
Note | Make sure the vacuum pump is properly positioned in the bracket. The vacuum connection faces in the direction of travel. |
| –
| Use the two clips to secure the vacuum pump in the bracket. |
| –
| Insert the bracket with the vacuum pump in the two pins in the vehicle. |
| –
| Secure bracket with two new self-locking nuts (9 Nm). |
| –
| Fit new hose clip on vacuum hose. |
Caution | Take care not to damage the vacuum hose. The vacuum hose must be renewed if it is damaged. |
|
| –
| Use suitable pliers to fasten hose clip. |
| –
| Plug in electrical connector. |
|
|
|
