A1
Exploded view |
1 - | Bolt |
q | Self-locking |
q | Always renew if removed |
q | When loosening and tightening, counter-hold on guide pin |
q | 35 Nm |
2 - | Bleeder screw |
q | Before screwing in, grease thread with thin coat of lithium grease -G 052 150 A2- |
q | 10 Nm |
3 - | Protective cap |
4 - | Guide pin |
q | Lubricate before installing protective cap |
5 - | Protective cap |
q | Insert onto brake carrier and guide pin |
6 - | Brake carrier with guide pins and protective caps |
q | Replacement carriers are supplied assembled and with sufficient grease on guide pins |
q | If protective caps or guide pins are damaged, renew using repair kit. Use grease sachet supplied to lubricate the guide pins. |
7 - | Protective cap |
q | Push outer sealing lip onto piston |
8 - | Piston with automatic adjustment |
q | Apply a thin coat of lithium grease -G 052 150 A2- to piston |
q | Removing and installing → Chapter |
9 - | Seal |
q | Do not damage when inserting piston |
q | Removing and installing → Chapter |
10 - | Brake caliper housing with lever for handbrake cable |
q | Renew the brake caliper housing if there is a leak at the lever for handbrake cable |
q | After repairing, pre-bleed brake caliper housing |