A1
| Exploded view of „Denso“ air conditioner compressor pulley - version „3“ |
Note| This type of pulley is installed e.g. on vehicles with air conditioner compressor version „6 SEU 14“. |
| 1 - | Cap |
| 2 - | Drive plate |
| q | Replace |
| q | Screwed to the air conditioner compressor drive shaft |
Note| Thread of new drive plate has been lubricated at factory with a pre-determined amount of a specific grease. |
| q | Different versions → Electronic parts catalogue |
| q | With overload safeguard; tripped in the event of excessive torque (e.g. stiff air conditioner compressor) and the pulley just free-wheels without driving the air conditioner compressor |
| q | With rubber elements for decoupling the pulley from the air conditioner compressor drive shaft and for damping vibration and noise |
| q | Removing and installing → Chapter |
| q | 30 Nm |
| 3 - | Circlip |
| q | Replace |
| q | Ensure correct positioning - flat side facing air conditioner compressor |
| 4 - | Pulley |
| q | Different versions → Electronic parts catalogue |
| q | Made of plastic, sensitive to impact |
| q | Removing and installing → Chapter |
| 5 - | Air conditioner compressor |
| q | Clean the air conditioner compressor drive shaft before fitting the pulley |
