audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Dismantling and assembling gearbox > < Removing and installing pendulum support

A1

Checking gear oil level and filling up with gear oil
Checking gear oil level and filling up with gear oil
l  For gear oil specification, refer to → Electronic parts catalogue.
   
–  Remove noise insulation -1- → General body repairs, exterior; Rep. gr.66.
  A10-11347
–  Remove gear oil inspection plug -arrow-.
Oil level is correct when gearbox oil is up to bottom lip of filler hole.
–  Tighten plug -arrow- to specified torque → Item.
Note the following when filling with new oil:
–  Remove plug -arrow-.
–  Fill up gear oil to bottom lip of filler hole.
–  Screw in plug -arrow-.
–  Start engine, engage a gear and allow gearbox to turn for approx. 2 minutes.
–  Switch off engine and remove plug -arrow-.
–  Top up gear oil again to bottom lip of filler hole.
–  Tighten plug -arrow- to specified torque → Item.
  V39-1959

Dismantling and assembling gearbox > < Removing and installing pendulum support