A1
Exploded view - hydraulics (LHD) |
1 - | Bolt |
q | 2x |
q | 20 Nm |
2 - | Clutch slave cylinder |
q | Removing and installing → Chapter |
3 - | Gearbox |
4 - | Bleeder screw |
q | Bleeding clutch system → Chapter |
q | 6 Nm |
5 - | Dust cap |
6 - | Clip |
q | To remove and install pipe/hose assembly, pull out clip as far as it will go |
7 - | Brake fluid reservoir |
8 - | Seal |
q | Seals must be fitted in supply hose |
q | Not available separately |
q | Renew supply hose -item 9- if damaged |
9 - | Supply hose |
10 - | Seal |
q | Seals must be fitted in supply hose |
q | Not available separately |
q | Renew supply hose -item 9- if damaged |
11 - | Clutch master cylinder |
q | Removing and installing → Chapter |
12 - | Seal / O-ring |
q | Push onto pipe connection |
q | Lubricate with brake fluid before installing |
q | Renew seal / O-ring if damaged |
q | Whether a seal or an O-ring is used depends on the type of connection → Fig. |
q | For correct version, refer to → Electronic parts catalogue |
13 - | Pipe/hose assembly |
q | Removing and installing → Chapter |
q | Disconnecting from clutch master cylinder and clutch slave cylinder → Fig. |
14 - | Bracket |
q | For pipe/hose assembly |
15 - | Seal / O-ring |
q | Push onto pipe connection |
q | Lubricate with brake fluid before installing |
q | Renew seal / O-ring if damaged |
q | Whether a seal or an O-ring is used depends on the type of connection → Fig. |
q | For correct version, refer to → Electronic parts catalogue |
16 - | Clip |
q | To remove and install pipe/hose assembly, pull out clip as far as it will go |
|
Item | Type of connection | ||
-1- | Connection with annular groove -arrow 1- | ||
-2- | Connection with shoulder -arrow 2- | ||
-3- | Connection with shoulder -arrow 2- and annular groove -arrow 3- | ||
|