Audi Workshop Service and Repair Manuals

Servicing gearbox housing and clutch housing

Special tools and workshop equipment required

t	Press tool -VW 408 A-

t	Spacer sleeve -VW 472/2-

t	Centring mandrel -12 - 551-

t	Press tool -30 - 555-

t	Threaded rod from assembly device -3066-

t	Thrust piece -3124-

t	Centring mandrel -12 - 551-

t	Punch -2026-

t	Thrust piece -T40008-

t	Torque wrench -V.A.G 1331-

t  -2-Puller -Kukko 18/1- t  -3-Splitter -Kukko 17/1-

Driving in input shaft oil seal until flush

Pulling out oil seal sleeve –  Apply spacer sleeve -VW 472/2- and press tool -30 - 555- to differential. A -  Puller, e.g. -Kukko 18/1- B -  Splitter 12...75 mm, e.g. -Kukko 17/1-

Drawing in oil seal sleeve A -  Screw threaded rod from assembly device -3066- into threaded piece in differential. B -  M12 nut with washer –  Turn nut -B- and pull sleeve in onto stop with thrust piece -3124-.   Note If gearbox has been dismantled, press in sleeve onto stop using thrust piece -3124-.

Driving out selector shaft sleeve -A-

Driving in selector shaft sleeve -A- to stop