Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Renewing oil seal for flange shaft (right-side) >
< Removing and installing flange shaft (right-side)
A1
Power transmission
6-speed manual gearbox 0A8, front-wheel drive
Final drive, differential, differential lock / Flange shafts and oil seals
Renewing flange shaft oil seal (left-side)
Renewing flange shaft oil seal (left-side)
Renewing flange shaft oil seal (left-side)
Special tools and workshop equipment required
t
Multi-purpose tool -VW 771- with puller hook -VW 771/37-
t
Thrust piece -3305-
t
Sealing grease -G 052 128 A1-
Procedure
–
Remove flange shaft (left-side)
→ Chapter
.
–
Pull out flange shaft oil seal using multi-purpose tool -VW 771- and puller hook -VW 771/37-.
–
Clean contact surface and sealing surface.
–
Lightly oil outer circumference of new oil seal.
–
Pack space between sealing lip and dust lip
-arrow-
half full with sealing grease -G 052 128 A1-.
–
Drive in oil seal onto stop using thrust piece -3305-. Take care to keep seal straight when installing.
–
Install flange shaft (left-side)
→ Chapter
.
–
Check oil level in gearbox and top up with gear oil if necessary
→ Chapter
.
Power transmission
6-speed manual gearbox 0A8, front-wheel drive
Final drive, differential, differential lock / Flange shafts and oil seals
Renewing flange shaft oil seal (left-side)
Renewing oil seal for flange shaft (right-side) >
< Removing and installing flange shaft (right-side)