audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
5-speed manual gearbox 02R > < Renewing oil seal for flange shaft (left-side)

A1

Renewing oil seal for flange shaft (right-side)
Renewing oil seal for flange shaft (right-side)
Special tools and workshop equipment required
   
t  Thrust piece -3305-
t  Sealing grease → Electronic parts catalogue
Procedure
  Note
t  → Chapter „Repair instructions“.
t  → Chapter „Rules for cleanliness when working on the gearbox“.
–  Remove flange shaft (right-side) → Chapter.
–  Pry out oil seal with assembly lever.
  W00-0695
–  Pack space between sealing lip and dust lip -arrow- half full with sealing grease → Electronic parts catalogue.
  Note
  N32-10016
t  Do not drive in thrust piece -3305- as far as stop!
t  The oil seal contacts the stop in the gearbox earlier than thrust piece -3305-.
t  It is therefore not possible to drive in thrust piece -3305- as far as the stop.
–  Drive in new oil seal until seal reaches stop (take care to keep seal straight).
  Note
If required, a new dust ring can be pressed onto flange shaft using tube -2010-. Do not use a hammer.
–  Install flange shaft (right-side) → Chapter.
  N39-10199

5-speed manual gearbox 02R > < Renewing oil seal for flange shaft (left-side)