Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing pendulum support >
< Exploded view - assembly mountings
A1
Power transmission
7-speed dual clutch gearbox 0AM (S tronic)
Gearbox mechanics,operation, construction,diff.
Exploded view - assembly mountings
Removing and installing gearbox mounting and gearbox support
Removing and installing gearbox mounting and gearbox support
Removing and installing gearbox mounting and gearbox support
Special tools and workshop equipment required
t
Support bracket -10 - 222 A-
t
Adapters -10 - 222 A /19-
t
Engine support bracket, basic set -T40091-
Removing
–
Remove air cleaner housing
→ Injection and glow plug system; Rep. gr.23
or
→ Injection and ignition system; Rep. gr.24
.
1.4 ltr. TFSI engine:
–
Detach coolant hose
-1-
from engine cover panel.
–
Unscrew bolts
-arrows-
and detach engine cover panel.
1.4 ltr. TFSI engine with supercharger:
–
Pull off engine cover panel (front)
-arrows-
and remove towards front.
Continued for all vehicles:
–
Remove nut
-1-
and bolt
-3-
and press electronics box
-2-
clear to one side.
–
Set up support bracket -10 - 222 A- on top edges of body flanges (left and right) and on longitudinal member (left-side), as shown in illustration.
–
Engage hook of spindle -10 - 222 A /11- in engine lifting eye (left-side).
–
Take up weight of engine with spindle; do not lift.
–
Remove bolts
-arrows-
from gearbox mounting.
–
Lower engine/gearbox assembly slightly via spindle of support bracket -10 - 222 A-.
–
Remove bolts
-arrows A, B, C-
and detach gearbox mounting.
Installing
Installation is carried out in reverse sequence; note the following:
l
Tightening torques
→ Chapter „Exploded view - assembly mountings“
Note
Renew bolts which are tightened by turning through a specified angle.
–
Bolt gearbox mounting to body
-arrows A, B, C-
; note tightening torque and sequence
→ Fig.
.
–
Pull gearbox up to support arm of gearbox mounting using spindle of support bracket.
–
Hand-tighten bolts
-arrows-
securing gearbox mounting to gearbox support initially.
–
Install air cleaner housing
→ Injection and glow plug system; Rep. gr.23
or
→ Injection and ignition system; Rep. gr.24
.
–
Install engine cover panel
→ Engine, mechanics; Rep. gr.15
.
Power transmission
7-speed dual clutch gearbox 0AM (S tronic)
Gearbox mechanics,operation, construction,diff.
Exploded view - assembly mountings
Removing and installing gearbox mounting and gearbox support
Removing and installing pendulum support >
< Exploded view - assembly mountings