Audi Workshop Service and Repair Manuals

Removing and installing oil pump Special tools and workshop equipment required

t  Counterhold tool -T10172-

Removing –  Remove sump → Chapter. –  Unclip cover -1- for chain sprocket for oil pump

–  Slacken off bolt for chain sprocket for oil pump several turns -arrow-; use counterhold tool -T10172- to counterhold at chain sprocket.

–  Use screwdriver to press chain tensioner in direction of -arrow-. –  Remove bolt for chain sprocket for oil pump. –  Detach chain sprocket from oil pump and take out of drive chain.

–  Remove bolts -arrows- and remove oil pump. Installing l  Tightening torques → Chapter „ Sump, oil pump - exploded view“   Note Renew the bolts tightened with specified tightening angle. –  Check whether dowel sleeves for centring oil pump and cylinder block are fitted; install missing dowel sleeves. –  Fit oil pump and tighten bolts.

–  Use screwdriver to press chain tensioner in direction of -arrow-.

–  Fit chain sprocket for oil pump l  Installation position: Sprocket can only be fitted on oil pump shaft in one position -arrow-. Remaining installation steps are carried out in reverse sequence; note the following: –  Install sump → Chapter.