l
| Engine oil temperature approx. 80 °C. |
–
| Connect oil pressure tester -V.A.G 1342- to bore for oil pressure switch. |
–
| Screw oil pressure switch -F1--item 2- into threaded hole in oil pressure tester. |
–
| Connect brown wire -1- of oil pressure tester to earth (–). |
–
| Connect voltage tester -V.A.G 1527B- with adapter leads from auxiliary measuring set -V.A.G 1594C- to oil pressure switch -F1- and battery positive (+). |
l
| LED should not light up. |
Note Renew oil pressure switch -F1- if LED lights up at this stage. |
Note Observe oil pressure tester and LED while starting engine, as switching point of oil pressure switch may already be exceeded when starting. |
l
| LED should light up at 0.3 ... 0.6 bar. |
–
| Renew oil pressure switch -F1- if LED does not light up → Chapter. |
Installation is carried out in the reverse order; note the following: |
–
| Install oil pressure switch -F1- → Chapter. |
|
|
|