| t
| The 6-digit adaption value -b- (details in illustration are only an example) is marked separately on each injector. The values may consist of letters and/or numbers. |
| t
| The 6-digit adaption value (example) is marked on each injector. It may consist of letters and/or numbers (ASCII code). |
| When a new injector is installed, the adaption value must be written into the engine control unit. |
| When a new engine control unit is installed, the „Adaption values for injectors“ must be written into the new control unit. |
| The adaption procedure is described in the „Guided Fault Finding“. (The procedure is also described under „Guided Functions“.) Use → Vehicle diagnostic tester |
| Also check that the values for the „Adaption for injectors“ for all other injectors are stored in the engine control unit. Do NOT attempt to re-enter these values if the correct values are already stored in the engine control unit. |
|
|
|
