audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Intake manifold > < Removing and installing air cleaner housing

A1

Removing and installing air mass meterG70
Removing and installing air mass meter -G70-
Removing
   
–  Pull off engine cover panel → Chapter.
–  Unplug electrical connector -1-.
–  Release hose clip -2- and detach air hose.
–  Unscrew bolts -arrows- and carefully pull air mass meter -G70- out of guide in air cleaner housing.
Installing
l  Tightening torque → Chapter „Air cleaner - exploded view“
To ensure that the air mass meter -G70- functions properly, it is important to observe the following notes and instructions.
  Note
t  If the air filter element is very dirty or wet, dirt or water could reach the air mass meter and affect the air mass value. This would lead to loss of power, since a smaller injection quantity is calculated.
t  Always renew O-ring for air mass meter if damaged (air leak).
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue.
The remaining installation steps are carried out in the reverse sequence.
  A23-10653

Intake manifold > < Removing and installing air cleaner housing