Injector (view from above) |
When a new injector is installed, the adaption value must be written into the engine control unit. |
When a new engine control unit is installed, the „Adaption values for injectors“ must be written into the new control unit. |
Additionally, check that the „injector delivery calibration values“ are correctly entered for all the other injectors. Do NOT attempt to re-enter these values if the correct values are already stored in the engine control unit. |
The adaption procedure is described in the „Guided Fault Finding“. (The procedure is also described under „Guided Functions“.) Use → Vehicle diagnostic tester |
|
|
|