audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Wheel runout compensation > < Requirements for test
Preparations for measurement
Preparations for measurement
Special tools and workshop equipment required
   
t  Brake pedal actuator -V.A.G 1869/2-
  W00-0679
t  For vehicles with air suspension: diagnostic tester e.g. -VAS 5052- with appropriate diagnosis lead
  W00-1206
t  Steering wheel balance -VAS 6458-
t  Wheel alignment computer approved by VW/Audi
l  Sensors must be properly attached and adjusted; refer to operating instructions of equipment manufacturer.
l  Ensure that the sliding plates and turntables are not touching the end stop when checking the alignment.
l  Drive vehicle onto wheel alignment unit and ensure that suspension is not under stress, if necessary by moving vehicle backwards and forwards several times.
l  Before starting the initial measurement and before making any adjustments, make sure that the steering is returned correctly to the centre position by turning the steering wheel uniformly in both directions using the steering wheel balance -VAS 6458-.
  W00-10694

Wheel runout compensation > < Requirements for test