audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing interior aerial 1 for entry and start authorisationR138 > < Removing and installing driver door exterior handle touch sensorG415

A1

Removing and installing entry and start authorisation control unitJ518
Removing and installing entry and start authorisation control unit -J518-
Removing
–  When renewing control unit select „Replacement“ function for appropriate control unit in „Guided Fault Finding“ or „Guided Functions“ → Vehicle diagnostic tester.
–  Remove glove box → Rep. gr.68.
   
–  Unplug electrical connector -3-.
  A96-10837
–  Unplug electrical connector by pressing catch -1- and moving retaining clip in direction of -arrow-; then detach connector.
  A90-0199
–  Release retaining tabs -arrows- and detach mounting -2- at central tube -1- from below.
  A96-10837
–  Release retaining tabs -arrows A- and take control unit -2- out of mounting -1--arrow B-.
Installing
Installation is carried out in the reverse order; note the following:
–  Install glove box → Rep. gr.68.
  A96-10838

Removing and installing interior aerial 1 for entry and start authorisationR138 > < Removing and installing driver door exterior handle touch sensorG415