audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Towing bracket > < Removing and installing anti-theft alarm sensorG578

A1

Removing and installing alarm hornH12
Removing and installing alarm horn -H12-
   
Removing
–  Remove wiper arms → Chapter.
–  Detach seal -2-.
  Caution
Risk of damage to cowl panel trim.
Apply a small quantity of soap solution to transition between windscreen and cowl panel trim.
–  Starting at edge of windscreen, carefully pull cowl panel trim -1- vertically up and out of retainer at windscreen -arrows-.
–  Remove plenum chamber partition panel → Rep. gr.50.
  A50-10151
–  Remove nut -1-.
–  Take out alarm horn -H12--item 4- (with bracket fitted) -3- to front.
–  Unplug electrical connector -2-.
Installing
l  Tightening torque → Chapter
Installation is carried out in the reverse order; note the following:
–  Install plenum chamber partition panel → Rep. gr.50.
–  Install wiper arms → Chapter.
  A96-10794

Towing bracket > < Removing and installing anti-theft alarm sensorG578